LIGHTLY (adv) In a light "manner" LIGHTLY RUB THE DEFECTIVE AREA WITH WET ABRASIVE PAPER.
LIMIT (n) A specified maximum or minimum quantity, number, time, or distance IF THE CLEARANCES ARE NOT IN THE LIMITS GIVEN IN FIG. 4, REFER TO REPAIR SCHEME XXXX.
limitation (n) LIMIT WHEN YOU LIFT THE AIRCRAFT ON JACKS, KEEP THE CENTER OF GRAVITY BETWEEN THESE LIMITS: Observe these center of gravity limitations when you jack the aircraft:
limited (adj) SMALL THERE IS ONLY A SMALL NUMBER OF REPAIRS THAT YOU CAN DO. There is only a limited number of repairs you can do.
LINEAR (adj) In a straight line (TN) MAKE SURE THAT THE RESULTS ARE LINEAR.
LINEARLY (adv) In a straight line (TN) LINEARLY INCREASE THE PRESSURE.
link (v) CONNECT, ATTACH CONNECT THE CABLES. The cables must be linked to each other.
ATTACH THE HOIST TO THE POWER UNIT. Link the hoist to the power unit.
LIQUID (adj) That has the properties of a liquid DURING SERVICING, THE LIQUID OXYGEN FLOWS THROUGH THE STABILIZING CONTAINER.
LIQUID (n) A material that is not a gas or a solid THE CONVERTER CHANGES THE LIQUID INTO A GAS.
list (v) RECORD, LIST (TN) RECORD THE TEST RESULTS. List the results of the test.
MAKE A LIST OF THE PART NUMBERS IN NUMERICAL SEQUENCE. List the part numbers in numerical order.
LISTEN (v),
LISTENS, LISTENED, LISTENED To use your ears (TN) to hear or find LISTEN FOR THE SIGNAL.
LIVE (adj) That includes explosive material
NOTE : For electrical systems, USE: ENERGIZE (v). SOME MAINTENANCE OPERATIONS ARE NOT PERMITTED ON AIRCRAFT THAT HAVE LIVE AMMUNITION.
load (v) LOAD (TN), INSTALL, PUT PUT THE LOAD ON THE SPRING BALANCE. Load the spring balance.
INSTALL THE SPRING IN THE CARTRIDGE. Load the spring in the cartridge.
PUT A FILM IN THE CAMERA. Load a film in the camera.
LOCAL (adj) Applicable to a given location or position SET THE "LAT" KNOB TO THE LOCAL LATITUDE.
LOCALLY (adv) Applicable to a given location or position YOU CAN ALSO DO THIS TEST WITH A LOCALLY MADE TOOL.
locate (v) FIND, ENGAGE, PUT USE TALCUM POWDER TO FIND EXTERNAL LEAKS. Locate external leaks with talcum powder.
ENGAGE THE GEAR WHEEL ON THE SPLINED SHAFT. Locate the gear wheel on the splined shaft.
USE THE MARK TO HELP YOU PUT THE CLAMP IN ITS CORRECT POSITION. Use the mark to locate the clamp position.
|
