时间：2011-08-11 18:26来源：蓝天飞行翻译 作者：航空 点击：次
|
滑油管路 oil line 滑油压力表 oil pressure indicator 滑油温度表 oil temperature indicator 滑油散热器 oil cooler 滑油量传感器 oil quantity transmitter 滑油压力传感器 oil pressure sensor 滑油温度传感器 oil temperature sensor 滑油滤旁通警告电门 oil filter bypass warning switch 润滑 lubrication/lubricate 润滑剂 lubricant 润滑组件 lubrication unit 探测器 detector 回油 scavenge 回油过滤 scavenge filter 主滑油/燃油热交换器 main oil/fuel heat exchanger 发动机滑油消耗高（滑油量快速减少）high engine oil consumption (oil quantity decreased at a quick rate) 发动机滑油压力/油量指示 Engine oil pressure/quantity indication 1) 高 High 2) 断续或空白 Intermittent or blank 3) 低（琥珀色） Low (amber) 4) 低或零（红色） Low or zero (red) 5) 不精确，断续，保持恒定或空白 Inaccurate, intermittent, remain constant, or blank. 6) AF 检查发现左发滑油箱口盖金属链丢失 Do AF check and find the metal chain of cap to oil tank at L/H is lost. 7) 航后检查发现后货舱滑油储备盒缺少2罐滑油。Two bottles of oil in the oil store box has been found lack during AF check. 8) 关车时左发滑油压力警告系统瞬时闪亮（红色）The oil pressure warning system of the L/H engine flashed(red light) when shutting down the engines. 9) 航后检查发现EEC自检有79-31342滑油压力DISAGREE信息。The information DISAGREE of the oil pressure appeared when doing the BITE of EEC AF check. 10) 重力添加发动机滑油 Add the engine oil by gravity filling procedure 11) 往启动机加滑油 Fill the starter with oil 12) Fill the CSD with oil 给CSD加滑油 13) Serve CSD spline with oil 用滑油勤务CSD花键轴 14) Replace oil supply filter element更换滑油供油滤滤芯 15) Replace scavenge oil filter element更换回油滤滤芯 16) Replace scavenge oil filter element更换滑油搜油油滤 17) Serve the engine oil by gravity fill procedure重力加油步骤勤务发动机滑油 ATA80 起动 起动 start 发动机振动指数高/空白/波动/为零。High/Blank/Fluctuating/Zero Engine vibration(VIB) 主发起动时，APU 排气出现刺耳噪音。APU exhaust made sharp noise when main engine started 发动机起动 engine start 1) 机组反映左发地面起动后起动电门无法自动返回off位 . The crew reported that the engine starting switch could not return to off position automatically. 2) 机组口头反映左发启动手柄至CUT OFF位时左发关车慢.The crew reported orally that the time of the L/H engine shut down slowly when putting the start lever to the CUT OFF position. 3) Replace L/H engine starter 更换左发启动机 4) Inspect magnetic chip detectors检查磁堵 发动机起动活门 engine start valve 1) EGT上升但点火不正常（即将发生热起动），燃油流量及管道压力正常，发动机已起动。EGT increased but ignition was abnormal (impending hot start), fuel flow and duct pressure indication was normal. |
